Redline 1501 Support Website
  • Home
  • Mini
  • 1501 Support
  • Contact
  • ec20

Error Codes

EC12 - Stop Position Error 
Solution - Turn the main shaft wheel to 100 degree or Press the 100 icon in the control panel and confirm.  

EC13 - Frame Over Limit
Solution - Because the parameters "Set Frame Protection" has been set and it is over the set range at moving the frame, user can release this parameter according to the situation.  

EC14  - Control Memory Lost


EC16 - Step Motor Error
Solution - 
1- Check whether the frame is blocked
2- Make sure the frame motor is OK.
3- Exam whether the drive is damage.
4- Re Power the machine.

EC17 - Change clr Overtime.
Solution -
1- Check whether the color-changing is rotating 
2- If it can rotate, please check the color changing rheostat, and the connection between that rheostat and color change motor.   

EC18 - Half Return Error.
Solution-
1- Use Color Changing wheel to correct the position of the needle.
2- Check whether the color change motor is damage 

EC20 - Main Motor Overtime

This error can be different things.

1-Normally this error appears  for obstruction in the main shaft because the lack of oil or something got stuck in the rotary hook
​
Solution - Turn the main shaft black knob to verified that there is no obstruction. If there is obstruction please inspect the machine to find the obstruction.

Solution - Turn the main shaft black knob to verified that there is no obstruction. If there is obstruction please inspect the machine to find the obstruction.

A- Inspect the rotary hook to see if there is obstruction there.

B- Due to the lack of oil some metal with friction expand causing the machine to jam.

Solution: Let the machine rest for 1 or 2 hours to see if the obstruction goes away, apply oil to all the oil points of the machine, check video https://www.youtube.com/watch?v=5pY1FvIjERA&t=45s

-Another possibility is the 100 degree  sensor : Inspect the sensor, clean the sensor or replace the sensor.
check video.
https://www.youtube.com/watch?v=r1Q9tMwq2NI&t=259s


- Bad Motor : Replace the main motor
- Bad   


EC21 - Change Clr Over Limit 
Solution - Check whether the color-changing rheostat is damaged and the whether the setting of "needles" is right.

EC22 - Main Motor Reverse 
Solution - Check the 14P Plug on the main shaft motor encoder is loose or the rheostat is damage.

EC23 - Can not Embroider 


EC24- Can not Frame Back


EC26- Can not trim 
Solution- Check whether it is due to mechanical reasons or knife return detection is broken.

EC37 - Pull Barr Error

EC38 - Spe Emb. Overtime

E41- File not Exist
Solution - Re-Perform the operation or perform the operation after re power or perform "Clear All Memory Designs"

EC42 - File Directory Full
Solution - Delete some designs.

EC43 - Memory Space Full
Solution - Delete some designs.

EC44 - File Fat Err
Solution - Re-Perform the operation or perform the operation after re power or Perform " Clear All Memory Designs"

EC45 - File Directory Error
Solution - Re-Perform the operation or perform the operation after re power or Perform " Clear All Memory Designs"

EC46 - Bad Disk Sectors
Solution - Replace disk.

EC95 - Thread is Broken, press key

EC101 - Transfer crc Error
Solution - Re Power the machine.
Picture
  • Home
  • Mini
  • 1501 Support
  • Contact
  • ec20